Table of Contents
Advertisement
STEP 1: UNPACK
TH E TV
Make sure to locate the remote control.
STEP 2: CONNECT
YOUR
TV
There are three types of connections
outlined
in this section:
TV Only:
If you're only going to connect the
TV to your home antenna or cable
system.
The Basic Connection:
If you're going to connect the TV to a
VCR or satellite
receiver.
Advanced
Connections:
If you're going to make multiple
connections,
hooking
up the TV to a
VCR and a satellite
receiver.
Cable information
and illustrations
are given for each type of connection.
Once you have completed
your desired connection
you may skip forward
to Step 3.
TV ON LY
This is a basic connection
from an antenna or cable system to your TV.
Connect the cable into the Cable/Antenna
jack as shown.
Important
Stand Information
CAUTION: Choose the location
for your "IV
carefully. Take precautions that the stand
or other furniture
on which the TV is
placed is properly located (see Important
Safeguards sheet) and of adequate
size
and strength
to prevent the TV from
accidentally
being tipped
over, pushed off,
or pulled off. This could cause damage to
the TV and/or personal injury.
Before
You Connect
Protect against power surges:
• Connect all components before
plugging any power cords into the wall
outlet,
• Turn off the TV and/or component
before connecting or disconnecting any
cables.
• Make sure all antennas
and cables are
properly grounded.
Refer to the
Important Safeguards sheet packed
with your TV.
Cables
You will use the following
cable to make your connection:
Coaxial
Cable: These cables carry audio and
video signals to the TV from an antenna, cable, or
cable box.
CABLE, CABLE BOX, OR ANTENNA
TV
CABLE/
CONTROL
ANTENNA
®
Once you have completed
this connection
you may skip to Step 3,
"Connect the IR Controllen"
4
Advertisement
Table of Contents
