RCA PS32108 Connection Manual page 27

Table of Contents

Advertisement

Trouble Checks
Trouble
Checks
and Adjustments
VC......._R (continued)
Can't record one channel
with the VCR while
watching a different
channel
on the TV
For connections
4B, 5B:
1. Turn on TV, VCR, satellite receiver, and cable box (if required).
2. Make sure [RD/'I'V switch on satellite receiver is in TV position so signal
from cable box or antenna is coming out the OUT TO TV jack on the
satellite receiver.
3. If cable box is required, use CHANNEL buttons on VCR to tune VCR to
output channel of cable box (usually
02, 03, or 04).
4. Select channel 03 or 04 on TV (depending
on the position of the
CH3/CH4
switch on the back of the VCR).
5. Select desired channel with CHANNEL buttons on cable box if cable box
is required.
If cable box is not required, select desired channel with
CHANNEL buttons on VCR.
6. Insert tape in VCR and press RECORD
on VCR.
7. To watch satellite channel, select channel 00 on TV.
8. Then select desired channel to watch with CHANNEL buttons on
satellite receiver.
For connections
4C, 5C:
1. Turn on TV and select channel 00 on TV with remote.
2. Turn on satellite receiver and select desired satellite channel with
CHANNEL buttons on satellite receiver.
3. Turn on VCR and set it to line mode (se e glossary) so you can see the
satellite signal coming into its AUDIONIDEO
IN jacks.
4. Insert tape in VCR and press RECORD
on VCR.
5. Press "I'VNCR button on VCR. This lets the cable signal flow directly
out of the OUT TO "IVjack of the VCR without affecting the recording.
6. If cable box is required, turn on cable box, change channel on TV to
output channel of cable box (usually 02, 03, or 04), and select desired
channel with CHANNEL buttons on cable box.
7. If cable box is not required,
select desired channel with CHANNEL
buttons on TV.
continued on the next page
25

Advertisement

Table of Contents
loading

Table of Contents