Table of Contents
Advertisement
C@nnect @ns
Netup
!Hiii!iiHiiiiiiii:{iiiii!
iiii!!iii!_iiiN
,
Highlight
tile channel
to which
you have
lo tune your TV in order
to see
cable
programming,
and press
OK (a screen
appears
reminding
you lo
connect
your G-LINK cable
lo your TV and cable
box).
Notes: Channel 03 is the most common.
Choose Videol/AUX if your cable box is connected to your TV with audio/video
cables instead of a coaxial cable. Go to page 7 for pictures of these cables.
For more information, go to cable box connection on page 9.
4.
Highlight your brand of cable box, and press OK,
If your brand isn't listed, highlight Not LL_/ed and press OK.
5,
Make
sure your cable box is on.
Tune
tile cable
box to channel
02 (use
tile remote
control
that came
with
your cable
box, or press
tile channel
buttons
on the cable
Ix)x).
Press OK (tile GUIDE
Plus+ system
starts testing
codes),
Important
Note: When code testing is in progress, don't touch your TV, VCR, cable
box or any of the remote controls for these products.
,
Look at your cable box. If it is still on and changed
to channel 09, tile lust
was successl\ll.
Highlight
Yes, and press OK (STF_3:
C'ot_/_gz_qn/4jbra VCR
appea*:s).
If your cable box didn't change to channel 09 or turned itself off, you have
two choices:
No and 7k, s t /bLs code again.
7},.s-t/bLscode again: If you drink tile TV, the cable box, or any of file remote
controls might have been touched
or bumped
during lhe test, highlight
7b._t
/bLs code again and press OK (the GUIDE Plus+ system runs the same set of
codes).
No: If you don't think the test was interrupted,
highlight No and press OK
(GUIDE Plus+ system k.sts the next code).
Rupeat tile previous instructions
until the TV finds file correct cable box
code. Follow the instructions
on lhe screen.
Note: If the TV can't find your cable box code, a troubleshooting
checklist appears.
Carefully
review each checklist and follow
the instructions
on the screen.
18
Chapter
I
Advertisement
Table of Contents
