About Programming The Remote; Programming The Remote To Control A Vcr - RCA G35851 Owner's Manual

ABOUT PROGRAMMING THE REMOTE
The universal remote can be programmed to control most brands
of remote controllable TVs, VCRs, and cable boxes. Most RCA,
GE and ProScan TVs and VCRs are already programmed. Other
manufacturer's brands need to be programmed.
PROGRAMMING THE REMOTE TO
CONTROL A VCR
To determine whether the universal remote needs to be
programmed, turn the VCR on, point the remote at the VCR,
and press the VCR1 button. Then press POWER or CHAN UP or
DOWN to see if the VCR responds to the remote commands. If
not, the remote needs to be programmed.
Follow these steps to program your universal remote to
control your VCR:
1. Turn on the VCR to be programmed. •
2. Look up your VCR brand and code number(s) on the code
list on the next page.
3. Press and hold theVCR1 button on the remote.
4. Enter the two-digit code from the code list.
5: •Release VCR1 then press POWER tO see if the VCR
responds tO the remote commands. If it doesn't, try
pressing VCR1 and POWER to see if the VCR responds.
This remote may not operate all
models of the brands that are
shown below. Use the codes on
the next page or on the sheet
packed with your remote.
To program the VCR2.LD button
to control a second VCR, follow
these steps but use the VCR2.LD
button instead of the VCR1 button.
24