Direct Access Tuning; Listening To Broadcasts Using Direct Access Tuning; To Cancel Frequency Input - Pioneer SX-303R Operating Instructions Manual

DIRECT ACCESS TUNING
[LISTENING TO BROADCASTS USING DIRECT ACCESS TUNING]
1
o'o
ooot
2 3
2
o
oolo o
oC
o
5
!-
When you know the frequency of the desired station, the frequen-
cy can be input directly using the STATION CALL (number) but-
tons in the following way:
1. Press the POWER switch to the ON position.
NOTE:
Be sure to turn the TAPE 2 MONITOR button OFF when listening
to AM or FM broadcasts.
2. Press the TUNER button and Select either FM or
AM using the FM/AM selector button.
3. Press the DIRECT ACCESS tuning button.
• If you do not perform any operations within five seconds of
pressing the DIRECT ACCESS button, direct access is can-
celed.
4. Input the desired station frequency using the
STATION CALL buttons.
Example 1: To receive FM 106.00 MHz
tL7 '--''_ I'_I-I;'
F. £371-'-- _ - c,_
t
Press the button * 6
FM []. LJ L_I _ -- ch
Press the button * 0
FOR MULTI-VOLTAGE MODEL
• When the CHANNEL STEP switch is set to FM 100 kHz step,
the tuning operation is completed and reception begins.
F,_ I L_I E-I. LJ L_I I I r-I L --chl
When the CHANNEL STEP switch is set to FM 50 kHz step:
!
i1-_ i_-:I-]>_'_-'lvl H -7 -o,-,
FM I L_I L_I. LJ/I"-I I L I
t
J Press the button * 0
1
,. t L7 S.L7 t:7I'qH Z -o. _--1
t
i
...... Press the button * 0
FM--/'I -_ ....... _ -- ch
l
FM / Ilk L- -- ch
i
__"_ I'4 _ H -'
_ r L_I_I_,
Z_
--oh
DIRECT
ACCESS
0
i
Press the DIRECT ACCESS
tuning button.
Once the station frequency has been input, the receiver tunes in
that frequency. If the input frequency falls below the lower or
higher limit of the receiver's receivable frequency range (FM:
87.5 MHz - 108 MHz; AM: 530 kHz - 1,700 kHz (10 kHz
step), 531 kHz -- 1,602 kHz (9kHz step) '_LOWER '_or _UPPER" is
displayed, indicating that the frequency which has been input can-
not be tuned in.
Press the button * 1
t
Press the button * 0
5. Adjust the volume with the VOLUME control and
the tone with TREBLE tone control, BASS tone
control and S.BASS button.
To cancel frequency input
Direct access is canceled when the DIRECT ACCESS tuning
button is pressed again.
Under the following conditions direct access is canceled and the
unit returns to the condition in effect before direct access was
selected:
If there is no key input for about five seconds after the
DIRECT ACCESS tuning button was pressed.
If more than about five seconds elapse between number
input.
10
<ARB1470>