Table of Contents
Advertisement
Using
the
Remote
Control
Indicator
Programming the Remote to Operate
Other Components
The universal remote can be programmed
to operate most brands of remote
controllable
components.
The remote is already programmed
to operate
most
RCA, GE, and Proscan components.
Also, tile AUX*HD button can be programmed
to operate
most brands of an
additional
remote-controllable
component
(such as a VCR, DVD player, satellite
receiver or cable box).
Note: The TV button
can't be programmed
on this remote.
Find Out If You Need to Program
the Remote
To determine
whether
the universal
remote
needs
to be programmed
to operate
one
of the components
connected
to your TV, such as a DVD player,
do file
following:
1.
Turn
on the component
(in this example,
a DVD player).
2.
Point
the remote
at the component.
3.
Press file corresponding
component
button
(in this example,
the DVD
button).
4.
Press ON*OFF
to see if the DVD player
responds.
If the DVD player
doesn't
respond,
you need
to program
the remote
to operate
it.
You'll use these buttons
when
you program
the remote.
Important:
The remote may not
be compatible
with all models of
all brands of components.
It also
may not operate
all functions
of
the remote that came with your
component.
To stop the automatic
code search without
programming
any components,
press and hold
CLEAR until the indicator
on the remote
turns
off.
Programming
the Remote
There
are two ways
to program
tile remote
control:
*
automatic
code
search
*
direct
ent_ T
Using Automatic
Code
Search
The t_llowing
instructions
can be used to program
tile remote to operate
each
of your components.
If you want to stop the automatic
code search without
programming
any" of your components,
press CLEAR until the indicator on the
remote turns off.
Note: The AUX*HD
button
on this remote is set by default
to search
for codes for DVD players only. If you want to program
it for use with a
different
component,
use the direct entry method.
1.
Turn
on tile component
you want
to operate
(VCR, DVD player,
etc.)
2.
Press and
hold the component
button
you want
to program
(DVD or
AUX*HD).
While
holding
the component
button,
press
and hold ON*OFF
until the indicator
on the remote
turns
on, _hen release
both
buttons.
3.
Point
the remote
at _he component.
Press and release
PLAY, _hen wait 5
seconds
or until the indicator
on lhe remote
stops
flashing.
At this point
the remote
is searching
for the correct
code
to program.
If,
after 5 seconds,
_he component
you want
to operate
does
not turn off,
press
PLAY again
to tell the remote
to search
the next set of codes.
20
Graphics contained
within tbis publication
are fi)r representation
on{l_.
Chapter
2
Advertisement
Table of Contents
