Picture - Philips 17PF9945-37 Directions For Use Manual

Use and Hookup Guide
Important Notice/Warning ..................... 1
Basic TV Operation .......................... 1
Remote Battery Installation .................. 1
Remote Control Button Descriptions ........... 1
Hooking up the Television
Basic Cable/Cable Box TV Connections ........ 2
Basic Antenna TV Connections ............... 2
AVI Input Connections ...................... 3
Component Video Input Connections ........... 3
High Definition Input Connections ............. 3
Headphone/Sub-woo fer_at a Jacks ............. 3
PC (Monitor) Connection .................... 4
AV2 Input Connections ...................... 4
AV3 Input Connection ....................... 4
Monitor Output Connections .................. 4
IMPORTANT
NOTE: This owner's manual is used with several
different television models. Not all features (and
drawings) discussed in this manual will necessarily
match those found with your television set. This is
normal and does not require that you contact your
dealer or request service.
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD DO NOT EXPOSE THIS UNIT TO
RAIN OR EXCESSIVE MOISTURE.
_this LCD television has a set of controls located on the top of
e cabinet for use when the remote control is not needed.
Press the POWER button on the front of the TV cabinet to
turn the TV ON.
Note: With AutoChron ON, the TV will search for a PBS chan-
nel to set the clock before powering itself on. This can take a
few seconds.
Press the VOLUME + button to increase the sound level or
the VOLUME - button to lower the sound level.
Pressing both buttons at the same time will display the
onscreen menu. After you are in the menu, use these buttons to
make Mjustments or selections.
Press the CHANNEL + or - button to select TV channels.
Use these buttons to make adjustments or selections in the
onscreen menu.
There is also a set of Audio and Video Input jacks located on both sides
and the bottom of the television cabinet. Refer to the Aarfio/Video
Hookup sections within this Guide.
To load the supplied batteries into the remote:
Remove the battery compartment door on the back of the
remote.
Place the batteries (2-AA) in the remote. Be sure the (+) and (-) ends of the batteries line up con'ectly (the inside of the case
is marked).
Reattach the battery compartment door.
Be sure Io point the remote at tI _
Remole Sensor window on the
fiont of the _elevision when using
the wmote control to operave the
television.
Remote Control
(shown from the bottom)
2 "AA" Batteries
Volume and Channel buttons are located
on the top of the television cabinet.
, Remote Sensor Window
DC Input located on the
bottom jack panel of the TV
00000 _
00000
Power Cord and Adapter
Batteny Compartment Door
Baaely Compartment
PIP Button - When in the PC Mode, pressing the PIP button will bring up a __
smaller second screen window _o view programming while using lhe TV as a com-
puter monilor.
Accessory Device 4141, II, I_, II"_,
1I
Buttons
- Press Io rewind, stop, play,_
fastforward, or pause/freeze a videotape, or DVD.
TV/DVD/ACC Mode Switch
- Slide to the TV position to control TV func- /_
tions, to the DVD posilion 1o control DVD Player functions, or _o the ACC position
to control the functions of accessory devices (a cable converter, DBS, or VCR, for
example).
Program List Button
- Press to display a list of channel numbers and their
names. Each channel will appear as a selectable menu item. Refer m lhe Program
List section wilhin the Directionsfi)r Use manual supplied with the TV for detailed
instructions.
/
Sleep Button
- Press to set the TV to automatically turn ilself OFF at a given
amount of time.
TV/VCR (A/CH) Button - TV/VCR - Press while in the VCR mode
indicalor on the front of lbe VCR will light) 1oview Ibe playback of a tape. Press
again to place in the TV position (the VCR indicalor light will go off) to view one
program while recording another program. A/CH - Press to toggle between the cur-
rently viewed channel and the pl_eviouslyviewed channel.
Auto Sound Button - Press to select an AuloSound
TM
control. Choos_
three faclory-set controls (VOICE, MUSIC, and THEATRE) and a PERSONAL 1o
tailor the TV sound to enhance lhe particular type of program you are watching./
Menu (Select) Button - Press for the onscreen menu to appear. Pressing lbe
menu button after menu selections are made will eliminate the menu from the dis-
play.
Active Coutrol Button - Press
O_. When ON, lhe sharpness and noise reduction will be continuously monitored.
Cursor Buttons (Left, Right, Up, Down) - Press these buttons Io highlight,
select, and adjust ilems on the TV's onscreen menu.
Volume (+) or (-) Buttons - Press to adjust the TV sound level. J
Mute Button - Press 1o turn the TV sound OFE Press again to return the sound 1o •
its previous level.
Status/Exit Button
- Press _o see the current channel number on the TV screen.
Also press to clear the TV screen after control adjustments.
®®6]
@®®
®®®.
@®®
p®o
Power Button - Press to turn the TV ON and OFE
Position Button - When using the PC Mode and the PIP window is present
on the screen, press the Position button to move the PIP window to any of the
four corners.
CC Button
- Press to select Closed Captio ring options within the menu.
(See the Direztionsfi)r Use manual for details.)
Clock
Button
- Press the CLOCK button to access the onscreen Clock
menu.
_Format Button - Press to toggle the different screen format options.
Source Button
- Press to toggle between the different A/V Input jack con-
nections and the currently tuned channel.
Auto Picture Button
- Press to select an AutoPicture'rr_ control. Choose
from four factory-set controls (MOVIES, SPORTS, WEAK SIGNAL, and
MULTI MEDIA) and a PERSONAL control that you set according to your
own preferences through the onscreen PICTURE menu. The four factory-set
controls will tailor the TV picture so _s to enhance the particular type of pro-
gram you are watching, or to improve the picture of a program that has a weak
signal.
Sun; Sound button
- Press to set various factory Incredible Surround
Sound listening modes. (Refer to the Incredible Surround section within the
_Directionsfi)r Use for detailed instructions.)
Channel (+) or (-) Buttons - Press to change the tuned channel.
Mode buttons
- Press to directly enter a specific mode, use the PC button to
place the TV in the PC (computer monitor) mode, press the HD button to
place the TV in the HD (high definition) mode, press the Radio button to place
the TV in the FM Radio mode, or the TV button to place the TV back to its
_ normal TV mode.
Number Buttons
- Press the number buttons to select TV channels. When
selecting single-digit channels, press the number of the desired channeL The
TV will pause for a few seconds and then tune to the selected channel. (Note:
You can press O, then the number also.) For channels lO0 and above, first
then the next two numbers of the desired channel.
- Press to select previously viewed channels. You can place up
m I0 channels in memory. Then by pressing the SURF button you can quickly
view the select channels. (See the "Using the Channel Surf Control" section in
your lnstructionsfi)r Use manual to see how to select a series of channels
using the Surf button.)
3139 125 31571