MTD 250 Operator's Manual page 7

6, Squeeze the line clutch control inward.
Insert right end into the hole on the right side
of the upper handle, Figure 3-5.
f
Figure 3-5: Install right end of line clutch controI
7
Assembly
NOTE: Stand behind
the tiller as if you were
going to operate it. Your
right hand corresponds
to the right side of the
tiller; your left hand
corresponds to the left
side of the tiller_
NOTE: This operator's
manual may cover
various models of tillers.
The units illustrated may
vary slightly from your
unit.
%,,¸¸