MTD 250 Operator's Manual page 6

Assembly
NOTE: Standbehind
the tiller as if you were
going to operate it. Your
righthandcorresponds
to the right side of the
tiller;your left hand
correspondsto the left
side of the tiller,
NOTE:Thisoperator's
manual may cover
variousmodelsof tillers,
The units illustratedmay
vary slightlyfrom your
unit.
IMPORTANT:
This unit is shipped
without gasoline or oil
in the engine. Fill up
gasoline and oil as
instructed in the accom-
panying engine manual
BEFORE operating your
machine.
,,.,, j
Assembly
1. Remove tile star handle knobs and carriage 4. Insert left end of tine clutch control intothe
bolts from the lower handle, Figure 3-1. hole on the left side of the upper handle,
Figure 3-3.
Figure3-1:Remove hardware fromlowerhandle,
2_ Position tile upper handle onto the lower
handle, Step A Figure 3-2. Align tile holes
on lower handle with the holes on the upper
handle (choose the upper or lower holes
depending on tile desired handle height).
3. Insert carriage bolts through the holes and se-
cure with star knobs, Step B Figure 3-2. Make
certain carriage bolts are seated securely into
one of the two positions provide&
f
Figure3-3: Instal leftsideof thetine clutchcontrol.
5. Insert the Z-fitting on the clutch cable into
the hole on the tine clutch control. Hook the
"Z" end into the opening from the inside to
the outside as shown in Figure 3-4.
Figure3-4: HookcableintolinecMch control
Rgure 3-2: Attach and secure upper handie,
6