Mitsubishi Electric 3D DLP 742 series Owner's Manual page 30

30 2. TV Menus
Setup, continued
Amm C hannems,
Add onmynew
channems
Scan
Edit
You must perform a channem scan to receive digitam channems, The scan searches for broad-
cast channels and adds them to TV memory. To start channel scan:
1, Highlight one of the input selections based on your connection to the ANT input:
Air when connected to an indoor or outdoor antenna.
Cabme when connected to direct cable (no cable box).
2, Select the scan type.
Select AH Channems for an initial scan or after moving the TV to an new area with a differ-
ent channel line-up.
Select Add onmy new channems to search for channels newly broadcasting since the
previous scan.
3, Press _ to highlight SCAN,
4, Press ENTER to start channel memorization.
See below for additional notes on Scan.
After channel scan, Edit lets you add and delete memorized channels. Memorized channels are
those you can tune using the OHkey. Edit the channel list to limit tuning to channels you watch.
Press OH/PAGE to jump to the next or previous page of channel numbers.
Press A V _( _ to move through all channel numbers, one at a time.
Adding/Demeting Channems Using the Channem Edit Menu
Channels marked with a check are in memory.
To add or delete a channel from memory, highlight
the channel number and press ENTER.
To add a single digital channel not in the list, see the
notes under Scan on this page.
Digital channels are listed by virtual channel number
with the physical channel number shown in small
gray text.
Virtuam Channem Number (digital channels only).
A channel number sent by a local broadcaster.
Physicam Digitam Channem Number. The
channel number officially assigned to the actual
broadcast frequency; shown on screen in gray
text.
Notes on Scan and Channem Memorization
Channel memorization may take up to 15 minutes to
complete.
To stop channel memorization before completion, press
CANCEL. Channels already added are retained.
When watching TV, press OH to move through
memorized channels. Press and hold OHto speed
through channels.
To add a digital channel that does not appear in the
Edit menu without performing channel memorization:
1, Look up the physical channel number for
the new digital channel. See the website
www.antennaweb.org for help.
2, Press INPUTand select the ANT input.
3, Use the number and CANCELkeys to enter the
physical channel number followed by "-1" and
ENTER. For example, for physical channel 36,
® ® ENTER.
The TV will search for a digital channel on the channel 36
frequency. When it finds the channel, it will:
a. Add the channel to memory.
b. Change the channel number to the virtual
channel number sent by the broadcaster.
c. Add to memory any associated sub-chan-
neHs.
Rememorize channels if you move the TV to a different
geographic area with a different channel line-up.
For assistance ca((1(800) 332-2119