Use Yourtv As A Pc Monitor; Use Philips Easylink; Use The Demo Mode - Philips 47PFL3704D User Manual

Use your TV as a PC monitor
Use an HDMI-DVI cable or an HDMI-DVI adaptor to connect a PC to
yourTV. For sound, add an audio cable with a stereo mini jack.
H Caution
• Before you connect your PC, set the PC monitor refi-esh raze to 60Hz,
Supported screen resolutions
The following screen resolutions are supported in PC mode:
Resolution Refresh rate
640 x 480 60Hz
800 x 600 60Hz
1024 x 768 60Hz
1280 x 768 60Hz
1280 x 1024 60Hz
1360 x 768 60Hz
1920 x 1080'* 60Hz
*In selected models only
If necessary, adjust the picture position to the center of the screen with
the cursor buttons.
Configure yourTV in PC mode
t Connect the PC to yourTV (see 'Connect a PC' on page 29).
_- Press MENU on the remote control and select [Features] >
[Mode Selection].
• [Mode Selection] appears for the followi% input signalsonly:
' • 720x480p@60 Hz
' • 1280x720p@60/Iz
' • 1920x1080p@24/25/30/50/60 Hz
TV menu
Features Mode Selection
Mode Selection
3 Select [PC] and press OK to confirm your choice.
4
If necessary, adjust the picture settings.
" Set the picture formaZ to [Unscaled] for wide screen PC resolutions.
5 Press MENU to exit.
Use Philips EasyLink
YourTV supports Philfps EasyLink, which enables one-touch play and
one-touch standby between EasyLink-complfant devices. Compliant
devices must be connected via an HDMI connector.
One-touch play
When you connect yourTV to devices that support one-touch play,
you can control yourTV and the devices with one remote control.
For example, when you press Play on your DVD remote control, your
TV automatically switches to the correct channel to show the DVD
content.
One-touch standby
When you connect yourTV to devices that support standby, you can
use yourTV remote control to put yourTV and all connected HDMI
devices in standby mode.You can perform one-touch standby using the
remote control from any of the connected HDMI devices.
Activate Master EasyLink
1 Press MENU on the remote control.
2
Select [Installation] > [Preferences] > [Master EasyLink],
3 Press A or T to select [On],
• Select [Off] to disable this function.
[Master EasyLink] must be activated in the [Preferences] menu to
make the [TV Speakers] menu available in the [Sound] menu.
Use the demo mode
You can use demonstrations to better understand the features of your
T_. Some demos are not available on certain models.When a demo is
available, it is displayed in the menu list.
t Press MENU on the remote control and select [Features] >
[Demo],
TV menu
Features Demo
*In selected models only
2
Press A or T to highlight a demo, and press OK to start the demo.
3 Follow the on-screen instructions to enjoy the demo.
4 Press MENU to exit.
22 EN