First Time Installation - Philips 32PFL7332D/37 User Manual

(ii First time instanationo, , "
Note: The first time (and only the _rst time) you turn on your set you see an installation introduction screen, The }nstallation procedure consists of a
ser_es of screens that guide you through the process.
O After an introduction screen, you are asked to select a language of the TV's on-screen-menus. (The text of the header and the infb on screen
continuously change language.)
Press the cursor up/clown to highlight your language.
Press the OK button,
Follow the on screen instructions to proceed.
Part 1: TV installation
(Please skip this section if you have no cable connected to the Antenna input of the TV, and continue with Part 2.)
Note - The TV will take approximately I0-15 seconds to start up.
Select the desired Language and press the green button "Next".
Select Cable or Antenna in the Installation mode and press the green button "Next".
O Auto Installation
may take 20 to 40 minutes
depending on the number of channels that are transmitted by the cable provider or
broadcaster.
O When the TV is not receiving any signal from the antenna/cable, the message CHANNEL NOT AVAILABLE will appear on the TV
screen. When no transmission is received from the broadcaster, a BLANK SCREEN will appear on the TV screen.
Note - The TV will go on to standby after 10 minutes. Press the POWER button on the remote control to turn on the TV.
O You will not be able to receive pay channels when using direct antenna/cable connection to the television.
O When the Set-top box is connected to the television using coaxial cable, itis necessary to auto-program the television forthe single channel
(3 or 4) that the Set-top box outputs and change the channels at the Set-top Box (using the set-top remote control) to view the program.
Refer to the manual for more details.
Note - The newly installed channels maybe sorted in a different sequence on this TV. Use the CH +/- buttons to get to know the new
channel. You can also use the OK button to see the list of channels.
O When the Set-top box is connected to the television using one of the AV connections (AV 1/AV 2/HDMI 1/HDMI 2), select that input
source (using the Source button) to view the programs and change the channels at the Set-top Box (using the set-top box remote control) to
view the program.
Part 2: Settings assistant
By means of several split screens/full screens you are prompted to select your preferred picture and sound settings, to finally arrive at a complete
setting which satisfies you.
Press the green color button on your remote control to enter the Settings assistant menu.
Select your Location with the cursor up/clown and press the green color button.
If you choose Shop it will skip the Settings assistant. The TV parameters for Picture and Sound will then be set to predefined fixed settings.
Press the green color button again to proceed.
If you choose Home it will display the Settings assistant.
O Use the cursor left/right to each time select your preferred screen.
O Press the green color button to each time confirm your selection and to jump to the following screen.
The following items will be presented sequentially. In the header it is mentioned how many screens have been completed and how many
screens there are in total. The Settings assistant will step sequentially through the following settings: Picture, Sound and Ambilight.
O Press the green color button once to store all the settings and to return to the TV installation menu.
Note: When you skip or stop the Settings Assistant, then the Standartl settings
Philips selected for you will be chosen.
Press the red color button to finish the First time installation procedure and to display the first stored TV channel