Programming The Remote - Zenith Z42PX2D Installation And Operating Manual

Programming the Remote
Programming the Remote
I1_ The remote is a multi-brand or a universaf remote It can be pr_rammed to operate most remote4-.,ontro_lable devices of
other manufacturers.
Note that the remote rr_3y not control a_t models of other b_nds.
1, To find out whether your remote can operate the device without programming, turn on the device such as a VCR and press the
corresponding mode button on the remote
After that, press the POWER button, if the device is turned off then it res_nds pro_dy and the remote need not to be pro-
grammed, if not, the remote should be programmed to operate the device. The programming procedures are explained below.
2, Press the MENU and MUTE button continuously at the same time for 2 secends_ the current selected device button will be il[u=
minatod.
If you den"t press any button for 20 seconds, the Uight on the mode button will be turned off. in that case you have to repeat from
step 2.
3. Enter code numbers using the number button on the retT_ote by refenng the code table on the following pages, When preying
the button, the light blinks at a time. If the device turned off, the programming is successful,
4. Press the MENU button to store the code. After blinking twice, this code is stored.
5. Test the remote functions to see if the device res_nds properly. If not, repeat from step 2.
52 Plasma TV 206_4022