Zenith Z42PX2D Installation And Operating Manual page 14

Ins_llation
3. Analog and Digital TV signals provided on cable and; antenna
f
Antenna Bronze Wire
Cable IV Wa_t t'um d®kwise to t_hien.
Jack RF Coaxial Wire (75 ohm)
- To improve the picture quatity in a poor signal area,
p_ease purcha_ a signal amplifier and instaJl properly.
° If the antenna needs to be split for two TVs install a '2-
Way Signal Splitter" in the connections,
° If the _tenna is not installed properly, contact your deah
er for assistance,
To avoid picture noise (interference), leave an adequate distance between the VCR and TV
Use the JSM Method (on the Option menu) feature to avoid having a fixed image remain on the screen for a long period of time.
if the 4:3 picture format is used; the fixed Jrr_ages on the sides of the screen may remain visible on the screen.
Connection Option 1
Set VCR output switch to channel 3 or 4 _d
then tune the TV to the same channel number.
Connection Option 2
1. Connect the audio and video c_bles from the
VCR's output iacks to the TV input jacks, as
shown in the figure.
When connecting the TV to VCR, rr_atch the
jack colors (Video = yellow, Audio Left = white,
and Audio Right = red).
if you connect an S-VIDEO output from VCR to
the S-VIDEO input, the picture quality is
improved; compared to connecting a regular
VCR to the Video input.
2. Insert a video ta_ into the VCR and press
PLAY on the VCR. (Refer to the VCR owner's
manuaJ .)
3. _lect the input source with using the
TViVlDEO button on the remote control Note
that this TV finds the connected input sources
automaticaJly for Video, Front Video and
Component 1-2. It is presumed that RGB and
HDMI!DW sources are connected.
Do not connect to both Video and
S-Video at the same time.
O []
VCR Rear
14 Plasma TV 206_4022