Remote Control Operation; Programming The Remote; Component Codes - Panasonic CT-27E33 Manual

REMOTE CONTROL OPERATION
Programming The Remote
The Universal Remote Control can be programmed to
operate many manufacturers' components, using the
component function buttons for VCR, DVD, CABLE or
DBS. Follow the procedures for programming your Remote
Control with or without a code for the component,
= .- . - m,.==,l_y'_Xlgl
TV TV (Panasoni¢Only) Panasonic Code
DBSICBL DBS\CBL (Preset) Panasonic DBSCode
VCR VCR (Preset) PanasonicCode
DVD DVD (Preset) PanasonicCede
Note: Determine the manufacturer of the component and look
in the table for the code (found on page 11).
Procedure
Confirm that the external component is plugged and
operating.
Turn the component off.
ACTION 0
Press • and together, for at least 5
Seconds.
Press appropriate component button on the Remote
Control VCR, DVD, CABLE or DBS
Enter the 3-digit component code using the Remote
Contmt numeric keypad (0 - 9 buttons).
Remote Control _ to test the
Press the
v
component. If the procedure was successful, the
component will turn on.
Note: If the component does not operate with the Remote
Control, repeat the procedure using another code.
(Some brands have multiple codes). If an incorrect code
is entered, or ff the procedure takes longer than 30
seconds, the programming will fail.
Programming Without A Code
This procedure searches all codes and is called the
"sequence method."
Confirm that the external component is plugged in
and on.
Turn the component off.
AO ONand 0
Press together, for at least 5
seconds.
Press appropriate component button on the
Remote Control.
Press VOL • to move forward to the next code.
Press • VOL to move backward.
Control _ to test the
Press the Remote
component. If the procedure was successful, the
component will turn on.
Note: Repeat the above steps until the component code is
found. It may take many attempts before the correct
code is found.
ACTION
After the code is found, press • to store the
code.
Component Codes
The Universal Remote Control is capable of operating
many component brands after entering a code. Some
components may not operate because the codes are not
available due to limited memory. The Universal Remote
Control does not control all features found in each model,
VCR CABLE DVD
DBS
10e