Table of Contents
Advertisement
6,
Hold glass door in place with the back
edge of glass flush with inside back edge
of upper & lower door hinges and against
top of the upper hinge, then tighten (4)
hinge screws per glass door.
7.
Repeat Steps 6 & 7 for the other glass
door.
8.
Once both glass doors are attached,
close them slowly to ensure doors are
aligned properly and the (2) strike plates
catch
on
to
the
cabinet
mounted
magnetic latches.
9.
If {he glass doors are binding anywhere
against the cabinet or each other they
are mis-aligned
and must be corrected.
10. To do so, simply loosen the Phillips head
screws on the side(s) that is not aligned
and adjust (move) glass door(s) accord-
ingly and re-tighten screws.
Shelves Mounting
Instructions
1.
The two cabinet shelves have been
mounted in the middle shelf position
with (8) metal shelf hangers (4 per
cabinet shelf) and for shipping, (4)
shipping
blocks
(2 per
cabinet
shelf). Remove these (4) shipping
blocks for free movement
of the
shelves.
in
Shelf
2.
Metal
Shelf Hanger
Hole in Cabinet
Side
3.
If the top or bottom
position
is
desired for mounting the shelf, lift
and hold or rest the shelf diagonally
while removing the (4) metal shelf
hangers
and
reposition
them
accordingly. Note: Do not use glue,
so you can change shelf position at
a later time if you wish.
Next, lift and rest shelf on one side
of the cabinets' shelf hangers and
then lower it down on the opposite
side.
,91------ Cabinet Side (Right)
Right Glass Door With
Hardware
Attached To
Door Hinges
Left Glass
Door
Cabinet Shelves
(Can be Set to 3
Different Positions)
Door
__.__
Hinge
Cabinet Mounted
Magnets
Y
_,,3 s
.
\J
J
x,...,)
Cabinet With Doors And Shelves In Place
- 37-
Door
--
Hinge
_
(2)
Strike
Plates
./
Right Glass
Door
Slight Space
Needed
Around
Perimeter of Both Glass Doors
for Proper Door Alignment and
Operation
Advertisement
Table of Contents
