LG LP1200SDR User's Manual & Installation Instructions page 11

ttOW lO USE
USING THE CONTROLS
FAN
Pressing the FAN button cycles the circulation
fan speed from low (F1) to medium (F2) to high
(F3).The selected fan speed
O ",_ will be shown in the LCD display.
FAN
J
The function can be used in
either COOL or FAN modes.
When changing fan speeds, there is a brief
delay before the fan motor changes speed.
A / Y (TEMP/TIMER)
In COOL and DRY modes, the A/V(TEMP/TIMER)
buttons adjust the set temperature up to 86°F or
down to 60°F, in one degree
_ A O_ increments. The temperature can
be switched between degrees
T Fahrenheit and degrees Celsius,
pressing theA button andV button
at the same time,or pressing °Cz°F button on the
remote.
When the TIMER function is selected, use the
A,/V(TEMP/TIMER) buttons to adjust the delay
time from 1 to 24 hours, in one hour increments.
If you press and hold the A/V(TEMP/TIMER)
buttons, the set temperature or time will change
automatically after a few seconds.
NOTE: The displayed temperature is the SET
temperature, not the room temperature.In COOL,
DRYor ENERGYSAVER mode, the thermostat in the
air conditioner will run the compressor until the
set temperature is reached, then cycle the
compressor on and off to maintain the set
tem pe ratu re.
TIMER
When theTIMER function is selected, you can set
the air conditioner to either automatically turn
iL Oi OFF °r turn ON after a delay °f
7_MER up to 24 hours. The display will
show 0.Use the A/V(TEMP/TIMER)
buttons to adjust the delay
time from 1 to 24 hours, in one
hour increments.
To set an automatic off delay, press the TIMER
button while the air conditioner is running and
use the A/V(TEMP/TIMER)buttons to adjust the
delay time. The air conditioner will automatically
turn OFF after the set delay.
To set an automatic on delay, press the TIMER
button while the air conditioner is off and use
the A/V(TEMP/TIMER) buttons to adjust the
delay time.
The display will show the number of hours
remaining until the unit is set to come on. The
air conditioner will automatically turn ON
after the set delay.
If you want to know how many hours you have
setted, press the TIMER button and then you
can see the time through the LCD display.
If you want to change the set timer,press the
TIMER button and adjust the time when the
number is flickering.
To cancel the Timer function,one method is
press the TIMER button and adjust the number
to"0" when the number is flickering,then the
function will be canceled in a few seconds.
Another better method is Press the TIMER
button and Press this button again when the
number is still flickering.
NOTE: Do not unplug the air conditioner when
using the timer function.