Direct Programming - Technics SD-S747 Operating Instructions Manual

......... _ ........ Press )_tO Start piayl ....................
[-_ To enter additional selections during
[_ play, repeat steps 3 and 4.
I
PROG_M __1 91SC
L? '--' ;
II'll
To clear all programmed contents
[In the stop mode]
Press II.
The display will look as below.
or Iw /0=
• #_ 17
[ .,-,
To quit the program mode
[in the stop mode]
Press PROGRAM.
The changer will return to the sequential play mode.
The programmed contents will remain stored in memory until they
are cleared, even after the program mode is canceled.
Therefore, after program, it is possible to cancel the program mode
and use another play mode and then hear the same program again
at a later time.
In addition, if discs are changed, the program will be played using
the new discs. If non-existiog entries are found at this time, the
changer will cancel them.
For your reference
The program will remain stored in memory even after the unit is
switched off.
However, if the power cord is unplugged or the power supply is oth-
erwise interrupted for an extended length of time, the contents witl
be erased from memory.
Speciat note on recording programs
The changer needs time to change the discs and find the tracks.
This time will vary depending on what you put into the program. In
any case, the total playing time will be longer than that of the actual
tracks.
Direct programming
You can add the track in play to your program.
In fact, a good way to build up your program is to listen to tracks
and add those you like while they are still being played. It sure
makes programming easier if you listen-and-program.
_r=_
PROGRAM •
(In the play mode)
Press DIRECT.
The current track will be added to the tail end of
the program.
Example Programmed order of the newly
added track
,c,"-_ E c,_ , '-': 7__J
IRECT
um natas for about 2 seconds when D is
pressed.
C;
Returns to the original indication.
Notes
• When you make a program as explained under "Program play" on
the left page, and then perform the above procedure without clear-
ing the program first, the selected track is added to the end of the
program.
• You cannot add to the program if already full, that is, if already 32
selections have been programmed. If you press DIRECT in such
case, the message "PGM FULL" will be displayed. Therefore,
direct programming is possible only when 31 or less tracks have
been programmed.
To listen to programmed tracks
(In the stopmode)
Press PROGRAM and check "PROGRAM"
appears on the display, then press _.
The programwillstartfromthe firsttrack.
Notes
During program play, the DIRECT button does not respond to
touch.