Panasonic SA-HE200 Manual page 8

Speaker connections
Front speakers (Q left _Dright)
Place on the left and right of the TV at seated ear height so
that there is good coherency between the picture and
sound.
Center speaker (_)
Place underneathor above the center ofthe TV. Aim the
speaker at the seating area.
Surround speakers (_ left Q right)
Place on the side of or slightly behind the seating area,
aboutone meter (3 feet) higherthanear level.
Surround back speaker (_))
Place behind the seating area (slightly to the left and right
if you connect two), about one meter (3 feet) higher than
ear level.
Subwoofer
(O)
The subwoofer can be placed in any position as long as it
is at a reasonable distance from the TV.
Note that some experimentation can yield the smoothest
low frequency performance. Placement near a corner can
increase the apparent output level, but can result in
unnatural bass.
The front, center, and surround speakers should be
placed at approximately the same distance from the
seating area. The angles in the diagram are
approximate.
Chan_e the speaker settinqs.
To get the best performance from this unit and the speakers you connect to it, you need to change the settings described
below. As you connect the speakers, circle the corresponding SPEAKERS and fill in the approximate DISTANCE from the
seating area. Now go to page 10 and change the settings as necessary.
SPEAKERS
Change to suit the size and number of speakers you connect.
LARGE: For speakers that can reproduce a furl sound range,
particularly the bass range below 100 Hz.
SMALL: For speakers that cannot adequately reproduce the
bass range. This setting is sufficient for most speakers
if you are using a subwoofer.
"SUB-WFR" is set to "YES" if you select this setting for
"FRONT".
NONE: For speakers you haven't connected (center, surround
or surround back). You cannot change the "SUR BACK"
setting if you select this setting for _SURROUND".
SINGLE: If you connect one surround back speaker to the
speaker terminal.
DUAL: If you connect two surround back speakers via a power
I amplifier to the pre-out terminal.
YES: If you connect a subwoofer
NO: If you do not connect a subwoofer.
"FRONT" is set to "LARGE" if you select this setting.
DISTANCE
Changesothe soundfrom the speakersreachesyou atthe sametime.
• Factory settings for SPEAKERS are underlined.
• Factory settings for DISTANCE are shown in _arentheses.
SPEAKERS
Q O
DISTANCE
FRONT (10)
O
CENTER
Q O
SURROUND
0
SUR BACK
SURROUND BACK
Q
SUB-WFR
(SUBWOOFER)
SMALL LAR_
NONE SMALL LARGE
NONE _MALL LARGE
NONE _ DUAL
YES NO
FEET
(10) FEET
(5) FEET
(5) FEET
Cable
Twist the wire
4.
Speaker terminals
Note
Do not short circuit.
If using 4-mm plugs
(-) Fully tighten the terminal,
then insert.