Troubleshooting - Panasonic SA-HE200 Manual

Troubleshooting guide
Before requesting service, make the below checks. If you are in doubt about some of the check points, or If the remedies indicated in
the chart do not solve the problem:
In the U.S.A., contact the Panasonic Customer Call Center at 1-800-211-7262, or e-mall consurnerproducts@panasonic.com, or web site
(http://www, panasonic.com).
In Canada, contact Panasonlc Canada Inc. Customer Care Centre at 905-624-5505, or web site (www.panasonic.ca), or an authorized
Servicentre close to you.
No power.
No sound.
Sound stops. "OVERLOAD"
appears on the display.
"F 70" appears on the display.
Ib,
• Ensure the power cord is connected.
• Turn the volume up.
• Check connections to speakers and other equipment.
• Turn on the speakers.
• Turn off the tape monitor.
• Select the correct source.
• Change the D-INPUT setting to suit the type of connection you have made.
• Check that the digital signals can be decoded by this unit.
• Turn PCM FIX or DTS FIX Off.
• Switch off the unit, determine and correct the cause, then switch the unit on.
Causes include:
-Shorting (bare wires touching) of positive and negative speaker wires.
-Using speakers with an impedance lower than that rated for this unit.
-Straining of the speakers through excessive volume or power.
-Using the unit in a hot environment without proper ventilation.
oTurn the unit off, disconnect the AC power supply cord, and consult your
dealer.
13
4-9
12
13
12
11
16
16
Sound Is not heard from the
center, surround, or subwoofer
speakers.
Sound is not heard from the
surround back speaker.
DSP sound modes cannot be
selected.
• Ensure the SPEAKERS settings for your speakers are correct.
• Check the DSP sound mode.
• Ensure the SPEAKERS settings for your speakers are correct.
• Turn ENHANCED SURROUND on.
• Turn DVD 6CH INPUT Off.
• The DSP switches to STEREO if input is PCM with sampling frequencies of
96 or 88.2 kHz.
10
16
10
16
12
16
The radio cannot be tuned in or
there is a lot of noise and
interference.
I,
• Connect the appropriate antenna. (You may need an outdoor antenna or one
with more elements.)
• Adjust the position of the FM or AM antenna.
• Reduce the treble.
• Select "SOURCE DIRECT".
• Turn off nearby televisions, video decks, DVD players, and satellite receivers.
• Separate the antenna from other cables, leads, and appliances.
7
18
16
im