NordicTrack GX2.0 User Manual page 8

6. 6
While another person holds the Console (13)
near the Handlebar (5), connect the console
wires to the Extension Wire (59) and the Pulse
Wire (61).
Insert the excess wire downward into the
Handlebar (5) or upward into the Console (13).
Tip: Avoid pinching the wires. Attach the
Console (13) to the Handlebar (5) with four M4
x 16mm Screws (90).
Wires
Avoid pinching
the wires
90
.
Orient the Upright (4) assembly and the Pivot
Cover (12) as shown.
Slide the Pivot Cover (12) upward to the
Handlebar (5). Tip: Bend and flex the Pivot
Cover slightly to slide it over the Handlebar.
Attach the Pivot Cover (12) to the Handlebar (5)
with two M4 x 16mm Screws (90) and two M4 x
22mm Screws (94).
Pivot the Handlebar (5) until the hole in the
Handlebar is aligned with an adjustment hole in
the Upright (4).
Tighten an Adjustment Knob (27) into the
Handlebar (5) and an adjustment hole in the
Upright (4). Make sure that the Adjustment
Knob is engaged in one of the adjustment
holes.
Hole
Adjustment
Holes
90
8