Back to Contents Page
Processor Heat-Sink Fan
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the Processor Heat-Sink Fan
Replacing the Processor Heat-Sink Fan
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
The heat sink may be very hot during normal operation. Ensure that it has had sufficient time to cool before you touch it.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the Processor Heat-Sink Fan
1. Follow the instructions in
Before You
2. Remove the back cover (see
3. Follow the instructions from
4. Remove the system-board shield (see
5. Disconnect the processor heat-sink fan cable from the connector (CPU FAN) on the system board.
6. Remove the two screws that secure the processor heat-sink fan to the chassis.
7. Carefully peel the silver foil from the processor heat sink.
8. Lift the processor heat-sink fan along with its cable away from the chassis.
NOTE:
The appearance of the system board may vary based on your computer model.
1
processor heat-sink fan cable
3
screws (2)
Replacing the Processor Heat-Sink Fan
1. Follow the instructions in
Before You
2. Align the screw holes on the processor heat-sink fan with the screw holes on the hex nut screws.
3. Replace the two screws that secure the processor heat-sink fan to the chassis.
Begin.
Removing the Back
Cover).
step 2
to
step 5
in
Removing the Front
Removing the System-Board
2
processor heat-sink fan
Begin.
Stand.
Shield).