3. Locate the 3-pin password reset jumper on the system board (see
NOTE:
The location of the password connector may vary depending on the system.
Inspiron 560
Inspiron 570
4. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
5. Turn on the computer, wait for approximately five seconds, and then turn off the computer. If required, press and hold the power button to turn off the
computer.
6. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3 to enable the password feature.