Setting Up The Monitor; Attaching The Stand; Connecting Your Monitor - Dell U2412M User Manual

Back to Contents Page

Setting Up the Monitor

Dell™ U2412M Monitor User's Guide
Attaching the Stand
Connecting the Monitor
Organizing Your Cables
Attaching the Soundbar (optional)
Removing the Stand
Wall Mounting (Optional)

Attaching the Stand

NOTE: The stand is detached when the monitor is shipped from the factory.
This is applicable for a monitor with a stand. When any other stand is bought, please refer to the respective stand setup guide for set up
NOTE:
instructions.
To attach the monitor stand:
1. Remove the cover and place the monitor on it.
2. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
3. Press the stand till it snaps into its place.

Connecting Your Monitor

WARNING: Before you begin any of the procedures in this section, follow the
To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
Connect the blue (VGA) cable from your monitor to your computer.
NOTE: If your computer supports a white DVI connector, connect the white DVI cable to the monitor and the white DVI connector
on your computer.
Safety Instructions.