Page 1
Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019. MTD LLC, P.O.BOX361131CLEVELAND,OHIO44136-0019 FORM NO. 770-10342D PRINTED IN U.S.A.
TABLEOFCONTENTS Content Page Content Page Customer Support Making Adjustments Important Safe Operation Practices Maintaining Your Lawn Mower Slope Gauge Troubleshooting Parts List Setting Up Operating Your Lawn Mower Warranty FINDINGMODELNUMBER This Operator's Manual is an important part of your new lawn mower. It will help you assemble, prepare and maintain the unit for best performance.
SECTION 1: IMPORTANT SAFEOPERATION P RACTICES WARNING" This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury.
Page 4
Never fuel machine indoors because flammable vapors will Slope Ope atio accumulate in the area. Slopes are a major factor related to slip and fall accidents which can Never remove gas cap or add fuel while the engine is hot or result in severe injury.
Page 5
SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE A POWER POLE Iq I A CORNER OF A BUILDING >_ 15 ° WARNING Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could &...
SECTION 3: SETTING UP Disconnect spark plug wire from the spark Spark Plug plug, and ground it against the engine. If engine is equipped with a rubber boot, ireX attach rubber boot to a bolt on the engine to ground. See Figure 1. _olt Plug Wire...
Page 7
RopeG@de Insert rope guide into the hole on the upper Squeeze handle indicated in Figure 4. Secure with wing handles nut E, but do not tighten. this way NOTE: Follow this step only if the rope guide is not Rope Wing Nut E attached to the mower.
SECTION 4: OPERATING Y OUR LAWNMOWER K ow your lawnmower Now that you have set up your lawn mower for Blade Control Handle operation, get aquainted with its controls and features. These are described below and Handle illustrated in Figure 6. This knowledge will allow you to use your new equipment to its fullest Recoil Starter potential.
Page 9
WARNING: Be sure no one other than the operator is standing near the lawn mower while starting engine or operating mower. Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas. Keep hands, feet, hair and loose clothing away from any moving parts on engine and lawn mower.
SECTION 5: MAKING ADJUSTMENTS ARNING: Always stop engine, disconnect spark plug, and ground against engine before performing adjustments. 8 Ii £ Hei£1t Height Adjustment Each wheel has a height adjustment leverto change the cutting height of the mower. Depress the lever towards the wheel and slide the lever assembly to desired position for a change in cutting height.
SECTION 6: MAINTAINING YOUR LAWNMOWER 88sepalS880mm®sdatisss • Always observe safety rules when performing any maintenance. • The warranty on this lawn mower does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain the lawn mower as instructed here. •...
Page 12
Blad®8a e ARNING: When removing the cutting blade for sharpening or replacement, protect your hands with a pair of heavy gloves or use a heavy rag to hold the blade. • Periodically inspect the blade adapter for cracks, especially if you strike a foreign object. Replace when necessary.
SECTION 7: TROUBLESHOOTING Engine fails to start Blade control handle disengaged. Engage blade control handle. Spark plug wire disconnected. Connect wire to spark plug. Fuel tank empty or stale fuel. Fill tank with clean, fresh gasoline. Blocked fuel line. Clean fuel line. Faulty spark plug.
Page 15
Series080 Ref. Ref. Part No. Part Description Part No. Part Description 747-1161A Blade Control Handle 736-0741 Bell Washer .760 ID x 1.25 OD 734-1987 Rear Wheel 8 x 1.8 749-1092A Upper Handle 710-0514 720-0279 Hex Cap Screw 3/8-16 x 1.0 Wing Nut 736-0270 Belt Washer .265 ID x .75 OD...
Page 16
MANUFACTURER'S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD LLC with MTD does not extend any warranty for products sold or respect to new merchandise purchased and used in the exported outside of the United States, its possessions United States, its possessions and territories.