Auger Control; Chuteclean-Outtool - MTD 31AH65LG704 Operator's Manual

Drift Cutters (If soEquipped)
The drift cutters are designed for use in deep snow. Their use
is optional for normal snow conditions. Maneuver the snow
thrower so that the cutters penetrate a high standing snow drift
to assist snow falling into the augers for throwing.
Heated Grips(If soEquipped)
_ AUTION: It is recommended that you wear gloves
when using the heated grip. If the heated grip
become too hot, turn it off.
I ON l OFF
To activate the heated grips, move the switch found on the rear
of the dash panel into the ON position. To turn off the heated
grips, move the switch found on the rear of the dash panel to the
OFF position.
AugerControl
AUGER CONTROL
f
The auger control is located on the left handle. Squeeze the
control grip against the handle to engage the augers and start
snow throwing action. Release to stop.
The drive control is located on the right handle. Squeeze the
control grip against the handle to engage the wheel drive.
Release to stop.
_On select models, the drive control also locks the auger control
so that you can operate the chute directional control without
interrupting the snow throwing process. If the auger control is
engaged simultaneously with the drive control, the operator can
release the auger control (on the left handle) and the augers will
remain engaged. Release both controls to stop the augers and
wheel drive.
NOTE:Always release the drive control before changing speeds.
Failure to do so will result in increased wear on your machine's
drive system.
Steering Trigger Controls (If soEquipped)
STEERING TRIGGER CONTROLS
J
The left and right wheel steering trigger controls are located on
the underside of the handles.
Squeeze the right control to turn right.
Squeeze the left control to turn left.
CAUTION: Operate the snow thrower in open areas
until you are familiar with these controls.
ChuteClean-OutTool
_ ARNING! Never use your hands to clear a
clogged chute assembly. Shut off engine and remain
behind handles until all moving parts have stopped
before unclogging.
The chute clean-out tool is conveniently fastened to the rear of
the auger housing with a mounting clip. Should snow and ice
become lodged in the chute assembly during operation, proceed
as follows to safely clean the chute assembly and chute opening:
1. Release both the Auger Control and the Drive Control.
2. Stop the engine. Refer to the Engine Operator's Manual.
Remove the key.
3. Remove the clean-out tool from the clip which secures it to
the rear of the auger housing.
4. Use the shovel-shaped end of the clean-out tool to
dislodge and scoop any snow and ice which has formed in
and near the chute assembly.
5. Refasten the clean-out tool to the mounting clip on the
rear of the auger housing, reinsert the key and start the
snow thrower's engine.
While standing in the operator's position (behind the snow
thrower), engage the auger control for a few seconds to clear any
remaining snow and ice from the chute assembly.
SECTION 4 -- CONTROLS AND FEATURES
19