3_
t
Finish securing
chute control assembly
to chute support
bracket with wing nut and hex screw removed
earlier.
See Fig. 3-14.
Figure 3=14
4.
Insert the chute directional
control
rod into the support
bracket on the rear of the dash panel. See Fig. 3-15.
5_
6.
f
Remove the hairpin
clip from the rear of the chute control
assembly.
Insert chute directional
control
rod into rear of the chute
control
assembly.
Secure the chute directional
control
rod to the chute control assembly
with the hairpin
clip
removed
earlier. See Fig 3-16.
Figure 3=16
Standard CrankAssembly
Handle
1.
Place the shift lever in the forward-6
position
(if equipped).
2.
Observe the lower rear area of the snow thrower
to be sure
both cables are aligned
with roller guides
before pivoting
the handle upward.
See Fig. 3-17.
Figure 3=15
Figure 3=17
12 I
SECTION 3-- ASSEMBLY & SET- U P