Off-Season Storage - MTD 410 Series Operator's Manual

• Clean spark plug and reset the gap once a season.
Spark plug replacement is recommended at the
start of each mowing season. Check engine
manual for correct plug type and gap specifications.
• Clean engine regularly with a cloth or brush. Keep
the cooling system (blower housing area) clean to
permit proper air circulation. Remove all grass, dirt
and combustible debris from muffler area.
Lubrication
Figure 17: Lubrication Chart
BladeControl
Lubricate the pivot points on the blade control handle
and the brake cable at least once a season with light oil.
See Figure 17. The blade control must operate freely in
both directions.
Rear DischargeDoor
The torsion springs and pivot points should be
lubricated periodically with light oil to prevent any rust
or binding. The discharge door must work freely.
Wheels
Wheels require no lubrication. However, if the wheels
are removed for any reason, lubricate the surface of the
axle bolt and the inner surface of the wheel with light oil.
Engine oil may also be used.
Engine
Follow engine manual for lubrication instructions.
Off-Season S torage
If the lawn mower is not going to be used for 30 days or
longer, prepare the unit for storage. Follow the steps
below for proper storage of the mower.
• Clean and lubricate mower thoroughly as described
in the lubrication instructions.
• Refer to engine manual for correct engine storage
instructions.
• Coat mower's cutting blade with chassis grease to
prevent rusting.
• Store mower in a dry, clean area. Do not store next
to corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rust-proof the equipment. Using a light oil or
silicone, coat the equipment, especially cables and all
moving parts.
14