Table of Contents
Advertisement
Using
the
active
A/V Network
(cont.)
using
the PLAY button
(AUTO PI_.kY)
When you press PLAY on the remote:
•
Active A/V Network
will turn your VCR on and bei_n playing
the tape (if any).
•
Active A/V Network
will turn your TV on and switch it to EXT-1.
When you turn your TV off:
• Your VCR will turn
off, unless
it is playing
or recording.
_>Important:
using
the PIP button
(TWO TUNER
PIP)
You must
be watching
a broadcast
channel
on Antenna-A
or An-
tenna-B
to use the Active A/V Network
PIP function
correctly.
When you press the PIP button
on the remote
to bring up a PIP
image:
• Your VCR will automatically
turn on.
• You can see the VCR's picture
in the small PIP image.
While the PIP image is on the screen:
•
The PIP function
buttons
(SOURCE,
CHANNEL,
ENTER,
right/
left, adjust
up/down,
PAUSE) will all work in the same manner.
•
The CHANNEL
and number
buttoas
(0-9) will automatically
control
the small PIP image.
You cannot change
channels
on
the main image.
When you press the PIP button
on the remote
to turn offthe
PIP
image:
•
CHANNEL,
the number
buttons,
and all other functions
will
work normally
again.
_Important:
DImportant:
If you turn offthe
TV wlhile it is set to EXT-1, it will return
to the
last channel
you viewed on Antenna-A
or Antenna-B
when you turn
the TV back on.
If you leave the TV turned on, set to EXT-1, but the 'IW is not
receiving
a signal on EXT-1, it will a_.tomatically
turn
off after five
minutes.
(If you use a TV menu during; this time, the TV will turn
off five minutes
after you stop using the! menus.)
_Important:
You should not press the PIP button while you are watching
a
channel
that
is not receiving
any broadcasts.
You will not be able
to see the small PIP image,
and you will not be able to change
channels
on the main image.
You may need to turn off the TV and
90
Chapter
4 : Using the Special
Features
Advertisement
Table of Contents
