Using The Remote Control - Mitsubishi CS-31303 Owner's Manual

Using the remote control
operating Mitsubishi components
This remote control unit comes programmed to ope:rate Mitsubishi
TVs and VCRs. The select buttons determine which component
the remote control will operate.
The following buttons are available for operation of' this TV set.
power button
pause button
mute control
super quick view button
quick view button
volume control
input button
channel control
enter button
audio a_d video controls
menu batton
cancel button
display button
home button
off-tiraer button
numb er buttons
PIP controls
42
_>Important:
operating VCRs from other manufacturers or cable box
The remote control is pre-set to operate Mitsubishi VCRs, but it can
also operate VCRs from other manufacturers as welh If you have a
VCR from another manufacturer, or if you have a cable box, it is
advisable to set up the remote control.
Each layer (CABLE, VCR-A or VCR-B) can be set for either a cable
box or a VCR.
<setting up the remote control to operate your VCR>
O Turn off your VCR.
Choose the layer using the select button on the remote controh
VCR-A, VCR-B or CABLE.
@
While holding in the POWER button on the remote control,
enter the code number listed in the chart on the following page
for your brand of VCR. Be sure to enter both digits of the code
number. (If more than one code number is listed, try the first
one. If that code does not work, try the next one until you find
the correct code.)
O Release the POWER button.
Press the POWER button again. Your VCR should turn on. If
the VCR turns on, your remote control is now set to operate your
VCR.
If your VCR does not turn on, repeat the instructions, trying each
code number listed for your brand of VCR.
Chapter 3: Operating Your TV