Mitsubishi CS-27205 Owner's Manual page 38

Setting up and using the remote control
(CS-27305 only) (cont.)
O Press the POWER button again. Your VCR should turn on. If
the VCR turns on, your remote control is now set to operate your
VCR.
If your VCR does not turn on, repeat the instructions, trying each
code number listed for your brand of VCR. If those numbers don't
work, try each number listed in the chart, 01 through 20.
setting up the remote control to operate your cable box
O Turn offyour cable box.
Set the TWVCR/AUX switch on the remote control to "AUX" or
"VCR."
O
While holding in the POWER button on the remote control,
enter the code number listed in the chart below for your brand of
cable box. (If more than one code number is listed, try the first
one. If that code does not work, try the next one until you find
the correct code.)
If your cable box is
this brand...
Zenith
Hamlin
Jerrold
G.I.
Oak
Pioneer
Scientific Atlanta
...enter this code
51
52,53,69
54,57,58,59,60,85,87
55,56
61,62,82
64,65,84
66,86,88,89,91,92
If your cable box is ]
this brand...
Toeom
Panasonic
Macom
Philips
Regency
...enter this code
67.,68,72
_;3,70
71
73,74,75,76,77,
93,94,95,96,97,98,99
79
_Important:
O Release the POWER button.
Press the POWER button again. Your cable box should turn on.
If the cable box turns on, your remote control is now set to
operate your cable box:.
If your cable box does not; turn on, repeat the instructions above,
trying each number listed for your cable box brand. If those num-
bers don't work, try each number listed in the chart, 51 through 99.
Sometimes manufacturers will change their products, or they may
use more than one code. If this is the case, your remote may not be
able to operate your VCR or cable box.
38 Chapter 3: Operating Your TV