Stacking Kit Installation - LG Steam Washer WM0001HTMA User's Manual & Installation Instructions

OPTIONALACCESSORIES
STACKING KIT INSTALLATION (cont.)
Dryer
Washer
/
Place the dryer on top of the washer by
fitting the dryer feet into the side brackets as
illustrated. Avoid finger injuries; do not allow
fingers to be pinched between the washer
and dryer. Slowly slide the dryer toward the
back of the washer until the side bracket
stoppers catch the dryer feet.
Insert the front rail between the bottom of
the dryer and the top of the washer. Push the
front rail toward the back of the washer until it
comes in contact with the side rail stoppers.
Install the two remaining screws to secure the
front rail to the side rails.
HOME CODE CLEAR
- Replacing or repairing (lost or broken) the monitor-
If you replace the monitor, reset the Home Code as detailed below.
AWARNING
_]_ The Home Code becomes cleared
automatically. After showing "HOME CODE
CLEAR IS PROCESSING...." for 3 seconds,
the machine is automatically turned off.
Use the method below when necessary.
O The appliance must be switched off.
After pressing the buttons listed below
simultaneously, turn the Power button on.
HOME CODECLEAR
IS PROCESSING . ... DONE.
58
The screen shows "HOME CODE CLEAR IS
PROCESSING...." as the power turns on,
and All LEDs are turned on.
HOMECODECLEAR
IS PROCESSING ....
+ "HOME CODE CLEAR IS PROCESSING..."
will display on the LCD.
+ "HOME CODE CLEAR IS
PROCESSING....DONE." will display on
the LCD, then the machine is automatically
turned off.
Home Code clear is completed.
O Set the Home Code the RLM.
on
If you replace the monitor, you must reset the
Home Code.