Timer And Sleep Operation; 17.Timer Button - Sharp SD-AT1000 User Manual

Timer and sleep operation

SD-AT1000H
ENGLISH
You can use the unit as an alarm clock by setting the timer.
Before setting timer:
1 Set the unit to the correct time (page 16).
If it is not set, you cannot use the timer function.
2 Prepare the sound source for playback.
3 Store radio stations (page 18).
E-29
" Setting the timer
1
Turn the power on and press the TIMER but-
ton.
Set the unit to the correct time if "TIMER STANDBY"
does not appear.
2
Within 10 seconds, press the or
select "TIMER SET", and press the ENTER
button.
3
Press the or button to adjust the hour and
then press the ENTER button.
4
Press the or button to adjust the minutes and then press the
ENTER button.
The start time is set and the finish time (1 hour later) will be displayed automati-
cally.
5
Set the time to finish as in steps 3 and 4 above.
6
Switch input with the or button,
and then press the ENTER button.
! When you select the tuner, select a sta-
tion by pressing the or button, and
then press the ENTER button.
! If a station has not been programmed,
"NO P-SET" will be displayed.
7
Adjust the volume with the or button and press the ENTER but-
ton.
Settings are displayed in order and the unit will enter the timer stand-by mode.
Caution:
This unit cannot set the timer of other equipment.
To perform the timer playback using other equipment, you should also set the
timer on the equipment separately.
03/3/14 SD-AT1000H_SEEG_E.fm
button to
DIGITAL1 DIGITAL2
TUNER LINE1
LINE3 LINE2
TINSZ0943AWZZ