Oven Door; Clocwtimer Display - KitchenAid YKERI201 Use & Care Manual

To Delay Start Self-Clean:
Before delay starting Self-Clean, make sure the clock is set to the
correct time of day. See "ClocWTimer Display" section. Also,
make sure the door is closed completely or it will not lock and the
cycle will not begin.
1. Press SELF CLEAN. To set a clean time other than 2 hours
30 minutes, press SELF CLEAN until the desired time is
reached. The clean time can be set between 2 hours
30 minutes and 4 hours 30 minutes.
2. Press STOP TIME.
3. Press the number pads to enter the time of day to stop.
4. Press START.
The start time is automatically calculated. Models with
electronic oven control Style 1 will display the start time. The
door will automatically lock, and "DOOR LOCKED" or
"LOCKED" and "DELAY" and the stop time will also appear
on the display (on some models). The door will not unlock
until the oven cools.
When the start time is reached, the oven will automatically
turn on.
When the cycle is complete and the oven cools, "End" will
appear on the oven display and "DOOR LOCKED" or
"LOCKED" will disappear from the display.
5. Press OFF to clear the oven display.
To Stop Self-Clean any time:
Press OFR If the oven temperature is too high, the door will
remain locked. It will not unlock until the oven cools.
If the oven temperature is too high after self-cleaning, then
"LOCKED" will appear on the display until the oven completely
cools.
IMPORTANT: Before cleaning, make sure all controls are off and
the oven and cooktop are cool. Always follow label instructions
on cleaning products. Soap, water and a soft cloth or sponge are
suggested first unless otherwise noted.
EXTERIOR PORCELAIN ENAMEL SURFACES
(on some models)
Food spills containing acids, such as vinegar and tomato, should
be cleaned as soon as the entire appliance is cool. These spills
may affect the finish.
• Glass cleaner, mild liquid cleaner or nonabrasive scrubbing
pad: Gently clean around the model and serial number plate
because scrubbing may remove numbers.
STAINLESS STEEL (on some models)
NOTE: Do not use soap-filled scouring pads, abrasive cleaners,
Cooktop Polishing Creme, steel-wool pads, gritty washcloths or
some paper towels. Damage may occur, even with one-time or
limited use.
Rub in direction of grain to avoid damaging.
• Stainless Steel Cleaner & Polish (sample included): See
"Assistance or Service" section to order.
• Liquid detergent or all-purpose cleaner: Rinse with clean
water and dry with soft, lint-free cloth.
• Vinegar for hard water spots
CERAMIC GLASS (on some models)
Do not use steel wool, abrasive powder cleansers, chlorine
bleach, rust remover or ammonia because damage may occur.
Always wipe with a clean, wet cloth or sponge and dry thoroughly
to prevent streaking and staining.
Cooktop Polishing Creme (sample included) is recommended for
regular use to help prevent scratches, pitting and abrasions, and
to condition the cooktop. It may be ordered as an accessory. See
"Assistance or Service" to order.
A Cooktop Scraper is also recommended for stubborn soils, and
can be ordered as an accessory. See "Assistance or Service" to
order. The Cooktop Scraper uses razor blades. Store razor
blades out of the reach of children.
Light to moderate soil
• Paper towels or clean damp sponge: Clean while the cooktop
is still warm. You may want to wear oven mitts while doing so.
Sugary spills (jellies, candy, syrup)
• Cooktop Scraper: Clean while the cooktop is still warm. You
may want to wear oven mitts while doing so.
Cooktop Polishing Creme and clean damp paper towel:
Clean as soon as cooktop has cooled down. Rub creme into
surface with a damp paper towel or soft cloth. Continue
rubbing until white film disappears.
Heavy soil, dark streaks, specks and discoloration
• Cooktop Polishing Creme or nonabrasive cleanser: Rub
product into soil with a damp paper towel or soft cloth.
Continue rubbing until white film disappears.
Burned-on soil
• Cooktop Polishing Creme and Cooktop Scraper: Rub creme
into soil with damp paper towel. Hold scraper as flat as
possible on surface and scrape. Repeat for stubborn spots.
Polish entire cooktop with creme and paper towel.
Metal marks from aluminum and copper
• Cooktop Polishing Creme: Clean as soon as cooktop has
cooled down. Rub creme into surface with a damp paper
towel or soft cloth. Continue rubbing until white film
disappears. The marks will not totally disappear but after
many cleanings become less noticeable.
Tiny scratches and abrasions
• Cooktop Polishing Creme: Rub creme into surface with a
damp paper towel or soft cloth. Continue rubbing until white
film disappears. Scratches and abrasions do not affect
cooking performance and after many cleanings become less
noticeable.
COOKTOP CONTROLS
Do not use steel wool, abrasive cleansers or oven cleaner.
Do not soak knobs.
When replacing knobs, make sure knobs are in the Off position.
• Soap and water: Pull knobs straight away from control panel
to remove.
OVEN DOOR EXTERIOR
• Glass cleaner and paper towels or nonabrasive plastic
scrubbing pad: Apply glass cleaner to soft cloth or sponge,
not directly on panel.
26