Diagnostic Display - Kenmore ELITE 153.331000 Use & Care Manual

DIAGNOSTIC DISPLAY
By simultaneously pressing the "Mode" and "down arrow" buttons for 3 seconds the unit will allow access to the diagnostic
mode.
In diagnostic mode, using the up/down arrow allows for cycling between diagnostic codes. The numeric display will
show the diagnostic code for 1 second, followed by the actual measurement displayed for 3 seconds. For example, H01
- 105 represents the diagnostic code of "H01" and the value of "105" is the inlet water temperature measurement. The
display will continue to show the diagnostic code and the measurement value unless the up or down arrows are pressed
to switch to the next item (see Table 3). If no buttons are pressed for 30 seconds the unit will revert back to operation
mode where the set-point temperature is displayed.
H01 Inlet Water H01 - xxx °C or °F 041 or 105 41°C or 105°F °C LED or °F
Temperature LED turned ON
H02 Heat engine outlet H02 - xxx °C or °F 041 or 105 41°C or 105°F °C LED or °F
water temperature LED turned ON
H03 Storage tank H03 - xxx °C or °F 041 or 105 41°C or 105°F °C LED or °F
temperature LED turned ON
H04 Heat engine water H04 - xxx litres/minute 056 5.6 litres/minute 1 titre =
flow rate (1.48 Gallons/ 0.264 Gallons
minute) 1 gallon =
3.78 litres
H05 Fan Speed H05 - x - xxx rpm 006_511 6511 rpm rpm=rotations
per minute
H06 Fan Current H06 -x- xxx mA 001_456 1456 mA mA=milliampers
(1.456A)
H07 Proportional Valve H07 - xxx mA 178 178 mA mA=mittiampers
Current
H08 Total Heating H08 - xxx - xxx hours 001_234 1234 hours
Time (51.41 days)
H09 Total Cycles H09 - xxx - xxx heating cycles 000_459 459 heating
cycles
H10 H10 - xxx KBtu/hour 100 100 KBtu/hour
H11 H 11 - xxx N/A E00 Proper operation
- No error
H12- H20 Hxx- xxx N/A E28 Ignition failure
The most
recent error
corresponds
to H12 and the
least recent to
H20
For the main
controller board
Heat Engine
Rated Output
Current Error
Code (See Fault
Code Table)
Error Code
History, From the
Most Recent to
the Least Recent
(See Fault Code
Table)
Software
Release Number
(CWHCB)
Software Release
Number (UIM)
Configuration File
Number
H21 H21 - xxx - xxx N/A 002 025 Software release
number 2.25
H22 H22 - xxx - xxx N/A 002_009 Software release For the display
number 2.09 board
H23 H23 - xxx - xxx N/A 000_006 Configuration file
number 6
TABLE 3
Part Number 320169-001 dRaFt Jun 9 130 47