Table of Contents
Advertisement
ROUGH IN DIMENSIONS
Dimension shown are in inches [cm]
47.38
[120.33]
58
_5]
Left Side View
o
37.03
[94.05]
3.41
[8.65]
23.63
[60.02]
8.00
[20.32]
Top View
FIGURE 2
31.98
[81.22]
Capacity,
Gas and Electrical
Characteristics
Model
153.331010
153.331000 HA
Approx. Capacity
Input
Gas
Type
U.S. Gals.
Litres
BTU/hr
25
94.6
100,000
Nat.
25
94.6
100,000
Nat.
Gas Supply Pressure
Max.
Min.
in. WC (kPa)
in. WC (kPa)
14.0 (3.49)
5.0 (1.25)
14.0 (3.49)
5.0 (1.25)
Manifold Pressure
in. WC (kPa)
4.2 (1.05)
4.2 (1.05)
Electrical Characteristics
Volts/Hz
Amperes
120/60
2.5
120/60
2.5
Minimum gas supply
pressure must be maintained
under both load and no load (dynamic
and static) conditions.
Manifold Pressure is preset on the gas valve by the manufacturer;
DO NOT ATTEMPT TO ADJUST!
Thermal efficiency is 90%.
If the hardness of your water supply is more than of 12 grains per gallon (200 mg/L), if your water supply is acidic or otherwise impure,
the water supply must be treated with approved
methods.
Top
0
Minimum Clearance To Combustibles
Front0
Vent0
Back0
I
Sides0
I
Floor0
Service Clearance
Front
Sides
21" (53.3 cm)
12" (30.5 cm)
Test Pressure
P.S.I.
300
This appliance
must be installed
in accordance
with local codes or, in the absence
of local codes,
the "National
Fuel Gas Code" ANSI
Z223.1IN FPA 54.
Not for installation
in a Manufactured
Home (Mobile Home).
This water heater is suitable
for water (potable)
heating
only.
This water heater is suitable
for installation
in a closet
or alcove.
10
Part Number 320169-001
dRaFt Jun 9 130
Advertisement
Table of Contents
