Panasonic TY-TP42P30K Installation Manual (Driver) page 24

Problem Check
Has the touch
panel been
removed?
Touched
position is
not aligned Has calibration
settings set
on the driver
software?
Is the Click
Mode setting
on the driver
software
correct?
Is the Click
Input Mode setting
response on the driver
differs software
correct?
If the problem is not solved even after taking the above actions, please contact your local Panasonic
dealer.
24
When the touch panel has removed and attached
again, the attaching position may be misaligned and
the touched position and the cursor position may be
misaligned. If the touch panel is removed, make sure
to set the calibration settings on the touch panel driver
software. Refer to "5-6. Calibration" for details on the
calibration settings.
When ne-tuning is required due to disparity or
other reason, follow the instructions in "5-7. Cursor
Adjustment" to ne-tune.
When a calibration setting is failed, the input position
on the panel and the mouse cursor position will be
misaligned. Set the calibration settings correctly. Refer
to "5-6. Calibration" of this manual for details on the
calibration settings.
When ne-tuning is required due to disparity or
other reason, follow the instructions in "5-7. Cursor
Adjustment" to ne-tune.
Refer to "5-2. Mode Setting, 2) Click Mode" in this
manual for the Click Mode settings on the driver
software.
Refer to "5-2. Mode Setting, 2) Click Mode" in this
manual for the Click Mode settings on the driver
software.
Action Page
P.19
P.19
P.14
P.14