Threading the needle
Switch off the master switch
Raise the presser foot lifter
(51). Place the
thread on the spool holder and fit an unwin
ding disk of the right size.
Using both hands, pull the thread into
thread
guide A from the front Place the thread from
right to left into the
pre-tension device B. Now
pass it through the left hand-threading slot
downwards. Pull the thread around the
stop C
in the right-hand threading slot and upwards to
the take-up lever
(40). The thread must be
pulled into the take-up lever from left to right
Pass the thread downwards in the right-hand
threading slot Pull the thread from the side
behind one of the
two thread guides
D.
To thread the needle, please refer to the next
page.