Getting Started with your Omron HEM790IT Blood Pressure Monitor
Welcome!
This guide will show you how to set up your
with Microsoft HealthVault.
With this guide, you will:
1. Set up your blood pressure monitor and take a test reading.
2. Get ready to use your blood pressure monitor with HealthVault.
3. Connect your blood pressure monitor to your computer and upload your test reading to
HealthVault.
IMPORTANT: If you have not already created your HealthVault account and installed HealthVault
Connection Center, please go to http://healthvault.com/connectioncenter and follow the instructions
Let's get started!
Step 1: Set up your blood pressure monitor and take a test reading
IMPORTANT: You will NOT be using the CD included with the device and may set it aside
IMPORTANT: The blood pressure monitor should not be connected to your computer
while you are taking a measurement. Before taking a measurement, please disconnect
the USB cable.
Open your blood pressure monitor packaging. Remember, you will NOT be using the CD
included with the device and may set it aside.
Remove the device, cuff, cords, and batteries from their plastic packaging.
Install the four AA batteries included or connect the AC adapter.
Set the date and time on your device as described below:
o If the device is on, turn it off by pressing the start/stop button
o Press and hold the 'Set' Button until the screen displays a flashing 'off'
o Press the set button again
o Set the year
o Set the month
o Set the time
and Microsoft® HealthVault™
Omron Blood Pressure Monitor (Model HEM-790IT) to work
If the year is not correct, press the button on the lower right to adjust
Once the year is correct, press the set button again
If the month is not correct, press the button on the lower right to adjust
Once the month is correct, press the set button again
If the time is not correct, press the button on the lower right to adjust
Once the time is correct, press the Start/Stop button
1
.
.