Philips RQ1285 User Manual page 54

english
54
5 Place the Jet Clean System back onto the cleaning
chamber.
Make sure the release buttons click back into place.
using the Jet clean system
Note: If you use the shaver with shaving foam or shaving gel, we
advise you to rinse it under the hot tap before you clean it in
the Jet Clean System. This guarantees an optimal lifetime for the
cleaning fluid.
1 Hold the shaver upside down above the holder with the
back of the shaver pointing towards the holder.
2 Place the shaver body in the holder behind the two clips
(1) and press it down until it locks into place (2).
, The display shows that the shaver is charging (see
chapter 'The display').
3 RQ1008: Press the up/down button to select a cleaning
program.
4 Press the on/off button on the Jet Clean System to start
the cleaning program.
, The shaver display stops showing the charging indication.
, The cleaning light starts to flash and the shaver is
automatically lowered into the cleaning fluid.
, The cleaning light flashes throughout the cleaning
program, which takes a few minutes.
Note: RQ1007: The cleaning program takes 4 to 6 minutes.