Important Safety Instructions; Stability Device; Tools - Kenmore 91193391890 Owner's Manual

IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Read all instructions before using this appliance. When using
gas or electrical appliances, basic safety precautions should
be followed, including the following:
• All Ranges Can Tip
Injury To Persons
Device Packed With
Range
Instructions
:!
Tools you wiJJ need:
o Phillips head screwdriver
• 1 3/8"open end or adjustable wrench
1. Remove the bracket from the
prepack located inside the oven.
2. Decide whether the bracket will be
installed on the right or left side of
range location,
3. tf the bracket side of the range is
adjacent to a cabinet, place the
bracket against back wall and
cabinet as shown in Figure 1.
If there is no adjacent cabinet,
determine where the location of
the range side (painted outside
panel) will be. Place the bracket
with its outside edge at this
location and against back wal!.
See Figure 2o
4. Determine whether you will anchor
the bracket to the floor or wall
Make sure this location is clear of
electrical wiring or plumbing.
Outside Edge Of
Bracket To Be
Or
Right Side Of Range
Fig. 1
m
Fasten the bracket securely with
the screws provided,. Screws are
self-drilling in wood, plywood,
particle and chip board, and most
metal framing, If attaching to
masonry, you can buy suitable
screws and anchors at hardware
stores, Use a masonry drill to drill
the required holes.
Bracket II Wall
Screw Must Enter "\ II Plate
Wood Or Metal... _1 /
%11111'
I_'_:_
Fig. 2 Attachment To Wall
m
1
Using the wrench, back out the
four feg levelers at least two turns,
See your installation guide for
more leveling information before
positioning range.
Slide the range into place. Be sure
rear leg leveler fully engages the
slot in the bracket.. If range cannot
be moved back far enough for
rear leg leveler to enter bracket,
move bracket forward as required
and attach to floor in new location,
3