Frigidaire CAQE7001LW0 Use & Care Manual page 7

Operating Your Dryer, continued
2 Check that the lint filter is clean and in place.
i
[
3 Load the dryer and dose the door.
* Load itemsloosely. The averagewet loadwill
fill the drum I/3to I/2full. Items need room to
tumble freely foreven dryingand less wrinkling.
o Ifdesired, p lacea dryerfabric softener sheeton
top ofthe loadatthe beginning ofthe cycle.
- To save energyand time and avoid uneven drying
and wrinkling, do notoverload thedryen
- When dryinglarge items, dryonlytwo or three
itemsata time.Fill out the loadwithsmall and
medium sizeditems.
- Fordelicate o r verysmallloads, add two or three
similar i temsto improvetumblingaction.
4 Select the appropriate cycle and settings for
each load,
Over-drying can cause wrinkles, shrinkage, lint,
harshness and a build up of static electricity.
Turn the cycle selector knob in either direction to
select the cycle desired.
The estimated drying time for Auto Dry cycles or
the actual drying time for Timed Dry cycles will be
displayed.
A suitable drying temperature, dryness level and
options will automatically be indicated for the cycle
selected. See the "Dryer Settings Chart" for more
details.
To change the drying temperature and dryness
level, press the Temp or Dry Level buttons to
scroll to the desired settings.
To select or delete an option, press Options; then,
while the indicator is blinking, press Select. The
indicator will light when the option has been se-
lected. It will no longer be lighted when the option
has been deleted.
If a setting is not available for the cycle selected, the
indicator will not light.
Adjustments made to a cycle will be remembered
and recalled each time that cycle is selected in the
future.
To return to factory settings, press the Start/
Pause and Select buttons at the same time and
hold until the signal sounds.
O s r_tze
O hq_ O hg O chime
o low o Low o shrink g_d o _y_m,
@ so d#,xu_
o _r d_y o damp o d_snpater o i,_;fi £ _,re e_se
L_'mp 4_
Press and hold both For ten seconds
to return to Factory settings.
5 Start the cycle.
To add or remove items when the dryer is running,
open the door. The dryer will stop when the door
is opened. Allow the drum to come to a complete
stop before reaching inside.
Close the door and press Start to resume the cycle.
6 When the cycle ends, remove items immedi=
ately and hang or fold,
Clean the lint filter after every load,