Table of Contents
Advertisement
Operating
Instructions
(continued)
TO CHANGE TEMPERATURE
DISPLAY:
temp/timer
auto
hi m
med
lo
]
V
ON-OFF
A
FANSPEED
fitter
reset
steep
YOU WILL SEE:
temp/timer
auto
1
hi _
fitter
med
lo
reset
V
ON-OFF
A
FAN SPEED
steep
DO THIS;
PRESSAND HOLD THE
UP/DOWN BUTTONS
TOGETHER FOR 3 SECONDS
TO TURN
UNIT OFF:
temp/timer
auto
1
hi ,
filter
med
lo
reset
V
ON-0FF
A
FAN SPEED
steep
Note: The control is capable of displaying temperature
in
degrees Fahrenheit or degrees Celsius.
YOU WILL SEE:
temp/timer
auto
]
lo
reset
V
ON=OFF
A
FAN SPEED
s[eep
ON/OFF BUTTON
ADDITIONAL
THINGS
YOU
SHOULD
KNOW
Now thatyou have masteredtheoperating procedure, hereare more features inyourcontrol thatyou shouldbecome familiar with.
• The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly.
/_
This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue
\
to run during this time.
It
to roll through to select another mode.
• The control will maintain the set temperature
within 2 degrees Fahrenheit, between 60F and 90F degrees.
• After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.
There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility of having
Fresh Air Vent Control
(on some models)
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (see Fig. 1)
2. Draw fresh air into the room - Fresh Air (see Fig. 2)
3. Exchange air from the room - Vent Open (see Fig. 3)
i
Figure 3 (VENT OPEN)
Figure 1 (VENT CLOSED)
Figure 2 (FRESH AIR)
©2009 Electrolux Home Products, [nc,
All rights reserved,
9
Advertisement
Table of Contents
