Table of Contents
Advertisement
This USE & CARE MANUAL
provides
specific
operating
instructions
for your
model.
Use the room
air conditioner
only as
instructed
in this USE & CARE MANUAL.
These
instructions
are not meant
to cover
every
possible
condition
and situation
that
may occur. Common
sense and caution
must be practiced
when
installing,
operating,
and maintaining
any appliance.
The power supply cord with
this air conditioner contains a current
detection device designed to reduce the risk
of fire.
i;
Please refer to the section 'Operation
of
Current Device' for details.
In the event that the power supply cord is
i;
damaged, it cannot be repaired. It must be
replaced with a cord from the product
manufacturer.
....
ii
Avoid fire hazard or electric shock. Do not
use an extension cord or an adaptor plug. Do
not remove any prong from the power cord.
For Your Safety
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance. Read product labels for flammability and other warnings.
Prevent Accidents
To reduce the risk of fire, electrical shock, or injury to persons when using your air conditioner,
follow basic precautions,
including the following:
Be sure the electrical service is adequate for the model you have chosen. This information
can be found on the serial plate, which is located on the side of the cabinet and behind the
grille.
•
If the air conditioner
is to be installed in a window, you will probably want to clean both
sides of the glass first. If the window is a triple-track
type with a screen panel included,
remove the screen completely before installation.
•
Be sure the air conditioner
has been securely and correctly installed according to the
separate installation
instructions
provided with this manual. Save this manual and the
installation instructions
for possible future use in removing or reinstalling this unit.
•
When handling the air conditioner, be careful to avoid cuts from sharp metal fins on front
and rear coils ....
Electrical Information
The complete electrical rating of your new room air conditioner
is stated on the serial plate.
Refer to the rating when checking the electrical requirements.
•
Be sure the air conditioner
is properly grounded.
To minimize shock and fire hazards,
proper grounding is important.
The power cord is equipped with a three-prong
grounding
plug for protection against shock hazards.
•
Your air conditioner
must be used in a properly grounded
wall receptacle. :If the wall
receptacle you intend to use is not adequately
grounded or protected by a time delay fuse
or circuit breaker, have a qualified electrician install the proper receptacle.
Remark: The appearance
of actual plug may
be slightly different from the line drawing
•
Do not run air conditioner
without outside protective cover in place. This could result in
shown in the figure. The line drawings are for
mechanical damage within the air conditioner.
reference only.
•
Do not use an extension
cord or an adapter
plug.
DANGER! Avoid Serious Injury
or Death
This air conditioner
contains no user-serviceable
parts. Always call an authorized Electrolux servicer for repairs.
Do not insert or place fingers or objects into the air discharge area in the front of the unit.
Do not start or stop the air conditioner
by unplugging the power cord or turning off the power at the electrical box.
Do not cut or damage the power cord.
[f the power cord is damaged, it should only be replaced by an authorized Electrolux servicer.
[n the event of a malfunction (sparks, burning smell, etc.), immediately
stop the operation,
disconnect the power cord, and call an authorized
Electrolux servicer.
•
Do not operate the air conditioner with wet hands.
•
Do not pull on the power cord.
•
Do not drink any water that is drained from the air conditioner.
02009
Electrolux Home Products, Inc.
All rights reserved.
Advertisement
Table of Contents
