Effortless Tm Oven Rack System And Assembly - Frigidaire CGEF3055MBB Use & Care Manual

Effortless TMOven Rack system (some models)
Some models are equipped with a special oven rack
system that automatically partially extends the oven rack
from the interior oven glides to assist in easier access to
your food items. This feature works whenever the oven
door is opened or closed.
To assemble the Effortless TM Oven Rack system:
1. Locate all required parts. You will need the supplied
oven rack (Effortless TM Oven Rack is a flat rack with a
special dark coating on the left and right rack
sides) and the 2 supplied chrome connector arms.
2. Open the oven door. Be sure the oven is completely
cool before proceeding.
3. Place the oven rack in positions 2, 3 or 4 only. Be
sure the rack connector brackets are at the rear of the
range and pointing towards oven bottom (See Fig. 2).
4. Assemble one connector arm at a time. With the oven
door open and the oven rack in place, install one end
of the connector arm to the hole in the door
connector bracket (Fig. 1) and the other end in the
hole in the rack connector bracket (Fig. 2 and as in
Fig. 3). The oven rack may need to be adjusted in or
out in the rack position to match the length of the
connector arm.
5. While holding the connector arm in place, twist the
connector arm so the ends of the connector arm point
upwards (See Figs. 4 & 5). The connector arm
should now be locked into position.
6. Repeat steps 4 and 5 for the other connector arm.
7. Once both connector arms are properly in place, be
sure to test the oven rack operation by gently closing
the oven door. The oven rack should move in and out
of the oven freely when the door is opened or closed.
• Only the Effortless TM Oven Rack system should
be used in oven rack position 2. Placing ANY other
rack in oven rack position 2 will prevent the oven
door from fully closing and may damage the oven
door, oven cavity or the door connector brackets.
• If the rack system is not assembled with the
connector arms the Effortless TMOven rack may be
used in oven rack positions 2 thru 6. Do not attempt
to use the Effortless TM Oven rack in rack position 1.
door rack connector
connector bracket
bracket
Fig. 1
con hector
Fig. 3 - assembly
of the Effortless
TM
Oven Rack
open oven
door
oven
rack
7
arm
Never pick up hot oven rack parts. Make sure the
oven and oven racks are COMPLETLY cool and safe to
touch before attempting to assemble or disassemble
........... the Effo !essm" OvenRack: .......................................................................................................................................
arm
Remove ALL oven racks and accessories before
starting a self-clean cycle. If the oven racks are left
in the oven during self-clean, the glide ability of the
EffortlessT_Oven Rack system will be damaged and will
cause oven racks to loose their shiny finish. Remove
ALL oven racks and clean according to instructions
provided in the Care & Cleaning section of this manual.
left and right
door connector
brackets
with connector arm ends
shown in locked position
(pointing upwards)
connector
arm
8
Fig. 6 - Effortless TMOven Rack after assembly