Supplied Accessories; Attaching Base; Symbols Used In This Manual; Mounting The Unit On Your Furniture - Emerson LC320EM2 Owner's Manual

6
Supplied Accessories
Owner's Manual Quick Start Guide Registration card
Remote Control
(NHO01UD)
Batteries
(AAA, 1.SV x 2)
TV base and 3 screws (M4 x 14)
If you lose the scrcws, please purchase M4 x 14 Ph IIps head screws
at your Iota store,
If you need to rep ace these accessor es, please rotor to the part
No, wth the ustrations and call our to free customer support
Ine found on the covor of this manua,
Vhm csrl _ unversa e so/;e con _'h to (pel_te ths un
Make sure the component code on your universa i_mote control
is set to our brand, Refer to the manual accompanying your
remote contl_l for more detaiB,
We do not guarantee 100% interopel abilty with all universal
romote contro s,
Symbols Used in this Manual
7he following s the descr ption forthe symbols used n ths
manual, Description refers to:
: D g]tal]V operat on
: Analog / Cable TV operation
If nether symbol appears, the operation s applicable to
both.
Attaching the Base
You must attach the base to the unt to have t as a table top
unit, Be sure the front and real" of the base match the propel"
direction, At least 2_people are requ red for these steps.
1 Check the text "FRONT" with "an'ow" on the Base's
bottom to ensure t is beng installed n the correct
direction, Spread a thick and soft cloth over a table as shown
at step 2, Place the main unit face down onto t. Make sure
not to damage the screen,
2. Insert 2_hooks under the
bottom of the main unt
into base holes. {shown by
an'ow 71)),then move the
base n the d tect on as
shown by an'ow @ until t
stops and the screw holes
are aligned, Make sure not to put the AC power cord
between the base and the unit.
Drve Ph Ilips head screws
into the 3 threaded holes
at the bottom of the base
until they are tight.
Io _ , hove the b;!se from hs ul
• Unscrew the Phillips head screws in step 3,
After the scrcws Is removed, move the base in the opposite
d rcction as shown by an ow in step 2, then pul the base up toward
the rear of the unt Be careful not to drop the base when you
remove It,
Note
When attaching the base, ensure that a screws are tightly fJstened,
Iftlqe base is not propel ly attached, it could cause the unt to fJII,
result ng n njuries as well as damsge to the unt
Mal<e sure to use a tabe vvl_ch can support the weight ofths unt
and s argot titan this unt
Make sum tl_e table s n s stable location,
When attaching the base, epsure that"FRONT" wth "arrow"
written on the bottom of the base is downwaJd, If t's not
downward, the Z hooks don't qt into the base,
Mounting the Unit onYour Furniture
Screw this unt on your futnture t ghtly using wood screw (not
supplied) in the hole at the bad< of the base as shown.
• Recommended sc_svv dimens on :3/16 x 3/4 nches(5,1 x Z0 ram)
rear of this unit
hole