Initial Setting; Initial Setup; Before You Begin - Emerson LC320EM9 3 Owner's Manual

[] Initial Setup
Thissection will guideyouthroughtheunit'sinitial settingwhichincludes
selecting a languageforyouron-screen menuandautochannel s can,
whichautomatically scans andmemorizes viewablechannels.
Before youbegin:
Makesureifthe unitisconnectedtoantennaorcables.
After making all the necessary connections, press
[POWER] to turn on the unit.
POWER
• This operation may take a few moments.
2 Use [Cursor A/T] to select the on-screen language
from the choices on the right side of the -IV screen.
(English / Espafiol / Franqais)
or
Note:
• If you connect the cable system directly, contact the CATV
installer.
• If you press [POWER] or [SETUP] during auto channel
scan, this setting will be canceled.
• The initial auto channel scan function can be executed
for either "Air" or "Cable" only once. When you change the
connection (Air/Cable), set auto channel scan again. (Refer
to page 13.)
• Youcan cancel or exit the initial auto channel scan menu
by pressing [SETUP].
• Ifthereisnosignalinputfrom theantenna terminaland
no operation for several seconds after you turn on the unit,
"Helpful Hints" appears. Follow the instructions listed on
the TVscreen.
• "Initial Setup" menu on step 3 will be displayed in the
selected language after you press [ENTER]
3 Use [Cursor AIr] to select"Air" for-IV channels or
"Cable" for CATV channels, then press [ENTER].
or
• Scanning and memorizing of channels start
automatically.
• When the scanning and memorizing of channels are
completed, the lowest memorized channel will be
displayed.
EN