Burner Locations - Electrolux CEW30GF6GSH Use & Care Manual

16
Setting Surface Controls
Operating single burners
1. Push the desired gas surface control knob in and
turn counterclockwise out of the OFF position -
2. Release knob and rotate to_ (litd/position.
Visually check that the needed burner has lit.
3. To adjust, push the knob in and tun counter-
clockwise to a flame size setting that best fits
your need.
Fig. !
Burner locations
0
0
2 Standard burners -9,500 BTU- best for most
surface cooking requiren7ents.
Large burner -14,000 BTU- best for bringing
large quantities of liquid to boil or when
preparing large quantities of food.
Min-2-Max TMdoubleburner-18,000 BTU-
Capabilities of large burner combined with a
simmer burner.
Perfect SimmeF Mburner -5,000 BTU- best for
simmering delicate sauces, melting
chocolates, etc.
Operating Min-2-Max TM double
burner
1. Push right front surface control knob in and turn
counterclockwise out of the OFF position-Fig. 1.
2_
Release the knob and rotate to the_l_ (lite)
position. Note: Although all electronic surface
ignitors will spark at the same time, only the
selected surface burner will lite.
3. Visually check that both the inner and outer rings
are lit -Fig. 4.
When both burners are lit, continue to turn the
control knob counterclockwise to adjust to the
desired flame size.
4. If only the inner burner is needed, continue to
rotate the gas control knob counterclockwise
somewhere past grsty area-Fig. 2.
5. Adjust the inner flame to desired size -Fig. ,2.
OFF J_ _1
Fig 2
Fig. 3
Fig,4
_,[:::]_ =1 [ :::], • [] . [] [_=
_FIE iFli j