Setting Surface Controls; Burner Locations - Electrolux EW3LDF65GSK Use & Care Manual

16
Setting Surface Controls
Operating single burners
1. Push the desired gas surface control knob in and
turn counterclockwise out of the OFF position -
Fig. 1.
2. Release knob and rotate to _Z. (lite) position.
Visually check that the needed burner has lit.
3. To adjust, push the knob in and turn counter-
clockwise to a flame size setting that best fits
you r need.
Fig. 1
Burner locations
O
O
Standard burners -9,500 BTU- best for most
surface cooking requirements.
Large burner-14,000 BTU- best for bringing
large quantities of liquid to boil or when
preparing large quantities of food.
TM Min-2-Max double burner-16,000 BTU-
Capabilities of large burner combined with a
simmer burner.
Perfect Simmer TMburner -5,000 BTU- best for
simmering delicate sauces, melting
chocolates, etc.
Operating Min-2-Max TMdouble
burner
,
,
,
Push right front surface control knob in and turn
counterclockwise out of the OFF position -Fig. 1.
Release the knob and rotate to the ,_
(lite)
position. Note: Although all electronic surface
ignitors will spark at the same time, only the
selected surface burner will lite.
Visually check that both the inner and outer rings
are lit-Fig. 4.
When both burners are lit, continue to turn the
control knob counterclockwise to adjust to the
desired flame size.
If only the inner burner is needed, continue to
rotate the gas control knob counterclockwise
somewhere past grey area -Fig. 2.
5. Adjust the inner flame to desired size -Fig. 3.
OFF _ _j _
Fig. 2
Fig. 3
Fig. 4