Solutionsto Common Problems; Burnerflameonlylightshalf Wayaroundburner - Electrolux E36GC75DSS1 Use & Care Manual

Hide thumbs Also See for E36GC75DSS1:

Table of Contents

Solutions to Common Problems

Surface Control knob has not been completely turned to LITE. Push in and turn the

Surface Control knob to LITE until burner ignites and then turn control knob to desired

flame size.

Be sure gas supply valve is open

Burner ports are clogged Clean burners See Cleaning the Burner Grates, Burner

Caps,Burner

Heads in General Care & Cleaning section With the burner off, clean

ports with a small-gauge wire or needle.

Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord is

securely plugged into the outlet.

Electrical power outage (electric ignition models only) Burners can be lit manually

See Setting Surface Controls in this Use and Care Guide

.....

iI '

IIIIIIIIIIIIIIIIIIIIII

• Burner ports are clogged. With the burner off, clean ports by using a small-gauge wire

or needle

•

Moisture is present after cleaning. Lightly fan the flame and allow burner to operate

until flame is full. Dry the burners thoroughly following instructions in the General

Cleaning section.

•

Dust particles in main line. Allow the burner to operate a few minutes until flame turns

blue.

In coastal areas, a slightly orange flame is unavoidable due to salt air.

Table of Contents